Residential drains are cleaned when they clog. Commercial drains are different. A restaurant that loses a floor drain on a Friday night, a duplex with a backed-up main line on the first of the month or an office building with a gurgling restroom has a business problem as well as a plumbing problem. The way to avoid that is to treat the drain line as equipment that needs maintenance.
This page covers how commercial drain work differs from residential, what is involved in grease line maintenance for food service, how property managers and multi-unit owners can plan and what a regular program looks like.
How commercial drains differ
More volume, more often. A commercial kitchen or a multi-unit building sends far more wastewater through a pipe than a single-family house.
Different waste. Restaurants send grease, food solids and starches. Multi-unit buildings collect waste from many households, with everything that comes with that. Retail and offices have more paper and, in some cases, wipes.
Shared lines. A single blockage can affect many units or fixtures.
Larger pipe and different access. Commercial lines may be four, six or eight inches, with cleanouts in mechanical rooms, parking lots or roof vents. Equipment needs to match.
Records matter. Health inspectors and landlords may both ask when a line was last serviced.
Timing matters. Service often needs to happen before opening, after close or on a weekend.
Restaurants and food service
Grease is the main problem. Fats, oils and grease, often shortened to FOG, wash down the drain warm and liquid, then cool and stick to the pipe wall. Over time the layer thickens until the line is mostly closed, and the plug that finally stops it is a symptom of months of buildup, not the cause.
Grease traps and interceptors. Most food service businesses are required to have a grease trap or interceptor that catches fat before it enters the sewer. These are pumped by a separate service. Pumping the trap does not clean the line downstream. The pipe between the trap and the sewer, and the lines inside the kitchen, still need attention.
Kitchen lines. The pipe from the sinks, the dish machine and the floor drains collects grease and food. A cable punches through it, but a jetter removes the layer. With a heated jetter the grease comes off faster, and some units can heat the water.
Floor drains and trench drains. Floor drains in a kitchen see steady use and collect solids. Trench drains need cleaning of the grates and the troughs as well as the line.
Signs of trouble. Slow floor drains, a smell from the kitchen drains, water pooling during dishwashing, a gurgling dish machine or a strong smell near the grease trap.
A jetting schedule for a restaurant depends on the menu, the volume and the cleanup habits. A fryer-heavy kitchen needs service more often than a salad counter. As a starting point, many food service businesses schedule monthly or quarterly. We recommend setting the interval after an initial cleaning and a camera pass, so the schedule is based on what the line looks like.
Property managers and multi-unit owners
Property managers have a different problem. Their tenants cause the clogs, but the manager pays for them and takes the call.
A shared main line. In a duplex, a fourplex or an apartment building, a single blocked main line affects every unit connected to it. The lowest unit, usually the ground floor or the basement, backs up first. Tenants in that unit take the damage that comes with it.
Frequent causes. Wipes, paper products, grease from tenant kitchens, and roots on older properties.
The cost of waiting. An emergency call, a tenant disruption and a cleanup in a unit typically cost more than a scheduled jetting. Backups also tend to land on weekends and holidays.
A scheduled program works like this.
- An initial inspection. A camera pass on the main line and the major branches, with a recording for the file.
- A first jetting. The line is cleaned and the condition recorded.
- A maintenance interval. Set by what the camera and the first cleaning showed. For a typical older multi-unit building, once or twice a year is common. For lines with heavy roots or grease, more often.
- A record. Dates, what was done and what was found, so the owner and the manager can document the property's condition.
- A review. Each visit, the technician reports changes. If the line is getting worse, you hear about it before it fails.
Property managers who handle many buildings get the most from a single schedule and a single point of contact.
Offices, retail and other commercial properties
Offices and retail spaces usually need less frequent service, but restrooms, break rooms and shared mains still back up. Strip malls often share a single sewer lateral across several tenants, including a restaurant, which means the grease from one tenant can block the line for all of them. A camera and a jetting before problems start is far cheaper than a shared emergency.
New tenants are a good moment to check. A camera inspection before a lease or a build-out shows the condition of the lines you are inheriting.
What a commercial visit involves
Before the visit, we ask about the building: the age, the number of units or fixtures, the location of cleanouts, the history of backups and the hours of operation. Then we plan around when the property can be accessed.
On site, the technician locates the access points, protects the area, runs a camera if the plan calls for it and cleans the line with the appropriate tool. They flush the line, confirm flow and give you a summary, with a copy of any video.
For a restaurant, work is often done before opening or after close. For a multi-unit property, we coordinate with the manager so tenants are notified.
Pricing depends on the building, the lines and the schedule. We do not post prices. Call for a quote, and ask about a maintenance plan if you want regular service.
Questions to ask any drain company
- Do you jet, and do you jet heated water for grease lines?
- Do you camera the line before and after?
- Will I get a written record or a recording?
- Can you work outside business hours?
- Can you set up a schedule and remind me?
- Who do I call at 9 pm on a Saturday?
Planning around busy periods
Timing is a big part of commercial drain work. A restaurant is busiest on weekend evenings and holidays, so the best time for a jetting is early morning before prep or late at night after close, on a day when a short delay costs the least. A property manager wants to avoid the first of the month, when move-ins and heavier use are common. Seasonal businesses should have lines cleaned before the season starts, not during it. When you set up a schedule, build in a buffer, so an unexpected finding on the camera, such as a belly or heavy roots, does not force a rush decision on the day.
Emergencies still happen even with a good schedule. A maintenance program does not make them impossible. It makes them rarer, and when they do occur, the technician already knows the line and the history, which speeds up the diagnosis.
Where we work
We serve commercial properties across the south Kansas City metro. That includes the restaurant and office corridors in Overland Park and Lenexa, apartment communities and older multi-unit buildings in Kansas City, MO, Grandview and Raytown, and downtown businesses in Lee's Summit and Olathe. See the service areas page for the full list.
